Final water coolers from the CoolPro – WE/WF series allow the efficient and economical purification of compressed air by cooling the air at the outlet of the compressor at an outlet temperature of only 10°C higher than that of the inlet water. This cooling causes condensation of up to 80% of the moisture present in the compressed air that can be separated thanks to an AS/MS centrifugal condensate separator installed at the outlet of the cooler.
The WE/WF final coolers consist of a shell and tube exchanger cooled in perfect countercurrent by a flow of cooling water.
Benefits:
-
Robust design suited to the extreme conditions of typically industrial tasks;
-
Helical exchanger pipes for maximum heat exchange efficiency and minimum pressure loss;
-
Heat exchange in perfect countercurrent;
-
Suitable for any requirement and application;
-
Combined condensate separators;
-
Flanges from WF225 to WF 6400 and nipple from WF 015 to WF 165 included.
Technical specifications:
-
Copper helical exchanger pipes;
-
Vessel made of carbon steel protected by primer painting + water-soluble acrylic varnish;
-
Centrifugal condensate separator included;
-
Maximum operating pressure: 16 bar(g) (WF015-1030) and 10 bar(g) (WF1250-6400);
-
Maximum temperature compressed air inlet: 200°C.
Accessories:
-
Version for vertical installation;
-
FixedXremovable tube and shell;
-
Version with copper pipes and layer made of carbon steel for standard applications;
-
Version with pipes and layer made of stainless steel for applications with aggressive cooling gas and water;
-
Version with stainless steel pipes and layer made of carbon steel for applications with aggressive gases;
-
Version for high operating pressure: 40 bar(g) and beyond (special);
-
Version with pipes and layer in copper-nickel for use in the marine environment;
-
Condensate drains: timed/capacitive.